Olabisi Onabanjo University OOU Engineering Courses and Admission Requirements

Browse the list of all engineering programmes at Olabisi Onabanjo University (OOU) Ago Iwoye, Ogun State in this page.

Presently, the university runs five (5) engineering courses in it's Faculty of Engineering and Environmental Studies. Each of  the courses is fully accredited by the Council for the Regulation of Engineering in Nigeria (COREN) and approved by National University Commission (NUC).

Listed below are all the taught engineering courses. They are all lasted for a duration of five years leading to students admitted to 100 level of the programme leading to the award of Bachelor of Science (BSc) degree in Engineering on completion of the study to successful students.

• Agricultural Engineering
• Computer Engineering
• Electrical and Electronics Engineering 
• Mechanical Engineering and
• Civil Engineering

Admission Requirements

There are two ways by which an applicant can gain admission to study any of the above courses in as much as he satisfy the admission requirements.

1. Through Unified Tertiary Matriculation Examination (UTME) this include Pre-degree programme which qualify students to be admitted into 100 level and
2. Through Direct Entry, including JUPEB and IJMBE which qualifies students to be admitted to 200 level.

Indirect Entry (UTME)

For a student to be considered for admission to undergraduate degree through UTME (1) above, he must have five credit passes from either

• West Africa Senior School Certificate Examination (WASSCE)
• Senior Secondary Certificate Examination (SSCE)/(NECO)
• General Certificate Examination (GCE)

The five credit passes must include: English Language, Mathematics, Physics, Chemistry and either Technical Drawing, Further Mathematics or Geography or Biology and it must not be at more than two sittings.

An applicant must pass Unified Tertiary Matriculation Examination (UTME)

UTME Subjects: Mathematics, Physics and Chemistry.


The applicant must also pass the Olabisi Onabanjo University (OOU) post UTME, making the required Cut-Off Mark for his chosen engineering programme.

Direct Entry Admission
Holders of the following results would be considered for an admission provided he make the minimum scores required

• GCE Advance Level (A/L)
• JUPEB
• IJMBE
• National Diploma and 
• Higher National Diploma

It is also required of a student to pass one or two combination of the three examinations above before he could be considered for an admission by direct entry.

Share this.