Kebbi State University Electrical Engineering Entry Requirements

Kebbi State University of science and technology, Direct Entry, Entry Requirements, JAMB' Subjects Combination, Electrical Engineering, electronics engineering
Study for a Bachelor of Engineering (BEng) degree in Electrical and Electronics Engineering at Kebbi State University of Science and Technology lasted a minimum duration of five (5) years and that is for those admitted through O'level  and JAMB examinations. Students who are admitted through direct entry application can use as low as three (3) years to complete the programme depending on the qualifications used to gain the admission

Listed below are the minimum entry requirements to study for the BEng degree in Electrical and Electronics Engineering at the Faculty of Engineering, Kebbi State University of Science and Technology.

JAMB's UTME Candidates

Five O'level credit passes in relevant subjects which must include:
  • Mathematics
  • English Language
  • Physics
  • Chemistry and one of the 
  • Technical Drawing
  • Geography
  • Biology
  • Further Mathematics
  • Building Constructions 
The five credit passes must not be at more than two sittings from one or two of the following examinations:
  • West Africa Senior School Certificate Examination (WASSCE)
  • Senior School Certificate of Examinations (SSCE)  or 
  • General Certificate of Education (GCE O'level)

JAMB' Unified Tertiary Matriculation Examination (UTME)

Students must sit for, pass and make cut off mark for the JAMB coordinated Unified Tertiary Matriculation Examination (UTME) and Kebbi State University of Science and Technology's coordinated post UTME.

JAMB Subject Combinations

  • Mathematics
  • English Language
  • Physics
  • Chemistry

Direct Entry Candidates

  • General Certificate of Education (GCE A'Level): Physics, Chemistry, Mathematics
  • National Diploma (ND): minimum of lower credit
  • Higher National Diploma (HND): minimum of lower credit
  • National Certificate of Education (Technical) 
  • Interim Joint Matriculation Board Examination (IJMBE)
The Department of  Electrical and Electronics Engineering may consider other higher education qualifications could be considered for an admission.

All direct entry candidates must have O'level results as stated above.

Share This.