This is a profession that applies the principles of Mechanical, Electronics, Computer and Robotics Engineering to design and develop automation and smart machines.
Mechatronics Engineering as a taught course at FUOTUOKE provide students with basic knowledge in the applicants of these engineering principles.
Listed below are the admission requirements accepted by the Department of Mechatronics Engineering, Federal University Otuoke from the O'level and direct entry applicants to the 100 level of the course plus the WAEC and JAMB subjects combination.
Admission Requirements (O'level Candidates)
Department of Mechatronics Engineering accept minimum of O'level credit passes in five subjects which must include: Mathematics
- Physics
- Mathematics
- Chemistry
- English Language and
- Any other science subject.
The five credit passes must not be more than at two sittings from one or two of the following O'level qualification exams:
- WASSCE
- NECO/SSCE
- GCE O'level and
- NABTEB
O'level candidates must sit for, pass and make the cut off mark for JAMB's UTME and for the Department of Mechatronics Engineering, Federal University Otuoke's Post UTME test.
JAMB Subjects Combination
- Mathematics
- Physics
- Chemistry
- English Language
This subjects combination is same for the post UTME test if it should be written.
Direct Entry Admission
The Department of Mechatronics Engineering, Faculty of Engineering, Federal University Otuoke accept minimum of
- National Diploma (ND): minimum of lower credit in relevant engineering courses.
- Higher Nationality is Diploma (HND): minimum of lower credit. Holder of upper credit could be considered to 300 level.
- IJMB: FUOtuoke accept good scores/points in Mathematics Physics and Chemistry
- JUPEB: good points in Mathematics, Physics and Chemistry
- GCE AL: good passes in at least two of Physics, Mathematics or Chemistry.
- Plus credit passes in five O'level subjects
Bachelor of Engineering (BEng) in Mechatronics Engineering is awarded students at the end of the five (5) years study.
The course is accredited by both the National University Commission (NUC) and Council for the Registration of Engineering in Nigeria.
Share This.