On this page is detail of the Mechanical and Production Engineering at Enugu State University of Technology (ESUT)
Below is listed the minimum entry requirements for O'level/JAMB and Direct Entry candidates to study for a Bachelor of Science (BSc) degree
n Mechanical and Production Engineering at Enugu State University of Technology (ESUT)
O'level/UTME Candidates
Minimum of credit pass in five (5) subjects which must include:
- Mathematics
- English Language
- Physics
- Chemistry plus one of
- Technical Drawing
- Further Mathematics
- Biology
- Geography or
- A Relevant Trade Subjects like
- Welding and Fabrication
- Data Processing and
- Auto Mechanic
- Metalwork
The five subjects must not be more than at two sitting from one or two of the following examinations qualification
- West Africa Senior School Certificate Examination (WASSCE)
- Senior School Certificate Examination (SSCE)
- General Certificate of Education (GCE O'level) or
- NABTEB
JAMB's Unified Tertiary Matriculation Examination (UTME)
O'level/UTME candidates must sit for, pass and make the cut off mark for UTME. He must also participate in Enugu State University of Technology (ESUT) coordinated post UTME screening making the Department of Mechanical and Production Engineering cut off mark.
JAMB Subjects Combination
- Mathematics
- Physics
- English Language and
- Chemistry
Direct Entry Candidates
The Department of Mechanical and Production Engineering, Enugu State University of Technology ESUT, accept these under listed qualifications from direct entry candidates
- General Certificate of Education, Advance Level (GCE A'Level): credit pass in Mathematics and Physics.
- National Diploma (ND): upper credits in relevant engineering courses
- Higher National Diploma (HND): upper credits in relevant engineering programme
- Joint Unified Preliminary Examination Board JUPEB:
ESUT conduct one year pre-degree programme for students who are short of mark to gain admission through UTME. Successful students in the programme are consider for admission to 100 level of Mechanical Engineering. Those given admission through direct entry are admitted to 200 level or 300 level depending on the qualification submitted for application.
Mechanical and Production Engineering at Enugu State University of Technology is accredited by National University Commission NUC, and Council for the Regulation of Engineering in Nigeria COREN.
Share This